I decided to keep these pics large. Here is the engine in the boat after installing it with my Father's bucket loader.

Another shot of the rigging starting to take place.

Puke tank and coil mount, DONE !

Got the home made wire sepatators installed and braided fuel and water lines done. I have to tidy up the lines also notice the stringer support plates that I made out of aluminum and have supports behind them as well.

I just like this picture. Notice the water pressure gauge and the home made thermostat housing.

One of the biggest problems with putting a blower on an 18 Ft. jet boat is the back seat will hit the pulley and belt. So I had to cut apart the seat and modify it.	Thanks to my Father for helping out with some oak and skill. Got the wood and boxed in everything for strength. I also glassed in the wood on the inside. It will be stapled back together by the same upholsterer who did the seats 2 years ago.

It Runs and Floats. Still need some more tuning.
Video Lake Zoar Mild Run